Zebra Technologies LP 2824 manual Assembly

Page 39

Replacing the LP Print Head (Continued)
Assembly
1.	Align the print head to plug the left
	and right connectors into the wire
	bundles.
2.	Slip the ground wire under the right
	screw and use a #1 Phillips driver to
	tighten in.
3.	Slide the print head into one side and
	jog it into the other side.
4.	Align the pivots of the bracket onto
	the posts; then, snap the bracket into
	place.
5.	Clean the print head with the cleaning
	pen.
Reload media. Plug in the power cord,
turn on the printer and print a status report
to ensure proper function.
980481-001A	31

Image 39

Contents Zebra LP 2824 TM 980481-001A Proprietary Statement Shock Hazard Contents Operation & Options 980481-001A Vii 980481-001A Hello IntroductionWhats in the Box? Opening the printer Inspecting the PrinterInspecting the Printer Closing the printer Reporting Damage Related DocumentationModes of Printing Getting StartedAttaching Power Supply Loading Roll Media Adjusting the Roll HoldersPlacing the Roll in the Media Compartment Using the Guides Status Light Power SwitchOperator Controls Feed ButtonMedia Length Sensing Interface Cable Requirements Hooking Up the Printer and ComputerSerial Interface Requirements USB Interface RequirementsParallel Interface Requirements Ethernet Interface RequirementsInternal ZebraNet PrintServer II Communications Communicating with the PrinterUniversal Serial Bus USB Communications Parallel CommunicationsSerial Communications CommandAdjusting the Print Quality Adjusting the Print WidthThermal Printing Operation & OptionsReplacing Supplies Printing in Peel-Mode Printing on Fan-Fold Media Using the Cutter Option 980481-001A Cleaning MaintenanceCleaning Card Considerations Print Head ConsiderationsMedia Path Considerations Platen Considerations LubricationAssembly Replacing the PlatenRemoval Replacing the Print Head Removal Direct-Thermal LP ModelAssembly 980481-001A What the Status Light is Telling You TroubleshootingPrinter Operation Media Handling Printed image does not look right Print Quality ProblemsPrint head is under temperature No print on the labelLabel format was sent to, but not recognized by, the printer Manual Calibration Communications Diagnostics Resetting the Factory Default ValuesPrinter Condition Feed Button Action Feed Button ModesUniversal Serial Bus USB Connector AppendixInterfaces Host Parallel InterfaceZebraNet PrintServer II for Ethernet Networks Looking into the Printer’s RJ-45 Modular ConnectorSerial RS-232 Connector Printer Serial RJ-11 Alternative Connector980481-001A