9412FA
3.Push the power supply partway into the bay. Leave the terminal block at the side of the power supply exposed.
Note: If you are installing a power supply in a new chassis, be sure to remove the bag of
Warning: Make sure the DC power source is off or disconnected on the remote end before you connect the terminal leads to the power supply. You may need to switch a circuit breaker or turn off the DC input power source.
+DC 
-DC
+DC
9415FB
4.Attach the grounding cable to the ground lug on the power supply.
Use the washers in this order:
•Flat washer
•Crimp lug
•Lock washer
•Hex nut
9427EB
5.Attach the positive and negative voltage leads to the positive and negative terminals on the power supply.
Use a lock washer between the crimp lug and each hex nut.
Use a
4