The Ultra Mouse comes with a NiMH battery pack already installed, but you will need to remove the plastic tab located inside the battery compartment. This clear plastic tab pre- vents the battery from discharging until you are ready to use your mouse. To remove the tab and charge your batteries:
1.Press the Battery Release button at the bottom of the mouse and lift the NiMH battery pack off.
2.Remove and discard the plastic tab.
3.Replace the battery pack by snapping it into place on the mouse.
4.Connect the power adapter to the charging cradle and plug it into a power source.
5.Place the mouse in the charging cradle. The cradle’s LED Indicator light, located at the bottom of the unit, will turn solid green and the LED Indicator light on the mouse will faintly flash green while its batteries are charging.
6.Once the batteries are fully charged, the LED Indicator light on the mouse will maintain a steady glow and will be ready for use.
Battery Tips
For optimal battery life, avoid using the mouse on dark- colored surfaces.
When the battery drops to twenty percent (20%) of its full charge, the LED Indicator light on the mouse will blink intermittently when in use. To optimize the performance of your NiMH battery, it is best to recharge it after every day of use.
If a full charge is not required, you can remove the mouse from the charging cradle at anytime. You do not need to wait for the LED Indicator light to stop flashing.
To conserve power, the mouse enters a “Sleep Mode” when it is left on for more than 24 hours. To awake from Sleep Mode, click any button.
2