Nortel Networks 70 Series manual DC Power Adapter

Installation and Reference for the BayStack 70 Series 10/100 Ethernet Switches

DC Power Adapter

The BayStack 70-8T 10/100 Ethernet Switch and BayStack 70-16T 10/100 Ethernet Switch are shipped with a power adapter and cord, as shown in Figure 1-7.

Power cord adapter

9331FA

Figure 1-7. DC Power Adapter

Warning: Use only the power adapter that was shipped with your switch to supply power to that switch. Read the amperage label on the power adapter to be sure it is the correct adapter for your switch.

Do not use the 8-port adapter (5 V DC/3 Amp) with a 16-port switch. Do not use the 16-port adapter (5 V DC/4 Amp) with an 8-port switch.

The BayStack 70-8T 10/100 Ethernet Switch is shipped with a 5 V DC/3 Amp power adapter. Be sure to use this 3 Amp adapter only with the 8-port switch.

The BayStack 70-16T 10/100 Ethernet Switch is shipped with a 5 V DC/4 Amp power adapter. Be sure to use this 4 Amp adapter only with the 16-port switch.

Cable Holder

A small plastic clip, or holder, can be screwed into the base of the switch to hold the power adapter cable in place. The hole for the cable holder is located on the bottom of the switch, near the DC power receptacle.

1-8 206375-A