Citizen CLP-9001, CLP-9301 user manual 47

Chapter 6 Configuring Your Printer Using The Menus

Group Menu	Menu Item	Default	Range	Description
* After Print	Cutter Type	Standard	Standard	Select cutter type. (“Cutter Type” is
			HeavyDty	shown when the optional device is
				installed.)
	Cutter Action	Backfeed	Backfeed	Set media feed direction. (“Cutter Action”
			Through	is shown when peeler unit is installed.)
				Backfeed: Always back feed media to
				top-of form after cutting operation.
				Through: Media stays present position
				after cutting operation.
	Paper Position	0.00IN	Function Off	Adjust media (paper) position for default
		0.00mm	0.00 − 2.00 in	media position.
			0.0 − 50.8 mm	Selected value will be 0.00 in (0.00 mm)
			Function Tear or	automatically if “Function Select” is
			PeelWait or Cut:	changed.
			- 1.00 − +1.00 in
			- 25.4 − +25.4 mm
	Rewinder Torque	4	1-5	Set rewinder torque. (“Rewinder Torque”
				is shown when peeler unit is installed.)
	Repeat Button	LabelSet	LabelSet	Enable or disable print label set with
			LastOne	REPEAT key pressed.
			Disabled	LastSet: Print next label set.
				LastOne: Print one label to be followed
				by the next label set.
				Disabled: Disable print label set.
* Interface	RS-232C Baud	115200	115200	Set serial interface baud rate.
			600	New value is valid after power is turned
			1200	off and on gain or a reset command is
			2400	issued.
			4800
			9600
			14400
			19200
			38400
			57600
	RS-232C Parity	None	None	Set serial interface communication
			Odd	parity.
			Even
	RS-232C Length	8 bits	8 bits	Set serial interface character length.
			7 bits
	RS-232C Stop bit	1 bit	1 bit	Set serial interface stop bits.
			2 bits
	RS-232C X-ON	Yes	No	Enable or disable serial interface X-ON
			Yes	flow control.
* Save Settings				Permanently save configuration values
				in non-volatile memory.
(continued)

− 47 −