Getting Started, Connecting the Power

About Your New Label Maker

With your new DYMO LabelManager™ 450D label maker, you can create a wide variety of high-quality, self-adhesive labels. You can choose to print your labels in many different sizes and styles. The label maker uses DYMO D1 label cassettes in widths of 1/4” (6 mm), 3/8” (9 mm), 1/2” (12 mm),

3/4” (19 mm), or 1” (24 mm). Label cassettes are also available in a wide range of materials.

Visit www.dymo.com for information on obtaining labels and accessories for your label maker.

Warranty Registration

Please complete the warranty registration card and return it to the appropriate Customer Support address within seven days of purchase. Visit www.dymo.com/registration for details.

Getting Started

Follow the instructions in this section to print your first label.

Connecting the Power

The label maker can operate on AC or battery power. To save power, the label maker will automatically turn off after two minutes of inactivity.

Inserting the Batteries

The label maker uses six 1.5 volt high-capacity AA alkaline batteries.

To insert the batteries

1.Remove the battery compartment cover. See Figure 2.

Figure 2

2.Insert the batteries following the polarity markings (+ and –).

3.Replace the battery compartment cover.

xRemove the batteries if the label maker will not be used for a long period of time.

Connecting the Power Adapter

An optional AC power adapter can also be used to power the label maker. Connecting the power adapter to the label maker disconnects the batteries as a power source.

To connect the power adapter

1.Plug the power adapter into the power connector on the top, left side of the label maker.

2.Plug the other end of the power adapter into a power outlet.

xMake sure the label maker power is turned off before you disconnect the power adapter from the main power source. Otherwise, your most recent memory settings will be lost.