Hotpoint Complete Guide to Oven Door Removal and Maintenance

affect the rust protection.

• The stainless steel or enamel-coated external parts and

Replacing the light bulb GB

the rubber seals may be cleaned using a sponge that

has been soaked in lukewarm water and neutral soap.

Use specialised products for the removal of stubborn

stains. After cleaning, rinse and dry thoroughly. Do not

use abrasive powders or corrosive substances.

• The inside of the oven should ideally be cleaned after

each use, while it is still lukewarm. Use hot water and

detergent, then rinse well and dry with a soft cloth. Do

not use abrasive products.

• All accessories can be washed like everyday crockery,

and are even dishwasher safe.

Lamp

Holder

compartment

Lamp

Glass cover

To replace the oven light bulb:

1.Remove the glass cover of the lamp-holder.

2.Remove the light bulb and replace it with a similar one: halogen lamp voltage 230 V, wattage 25 W, cap G 9.

3.Replace the glass cover (see diagram).

!Never use steam cleaners or pressure cleaners on the appliance.

Cleaning the oven door

Clean the glass part of the oven door using a sponge and a non-abrasive cleaning product, then dry thoroughly with a soft cloth. Do not use rough abrasive material or sharp metal scrapers as these could scratch the surface and cause the glass to crack. For more thorough cleaning purposes, the oven door may be removed:

1.Open the oven door fully (see diagram).

2.Use a screwdriver to lift up and turn the small levers F located on the two hinges (see diagram).

F

3. Grip the door on the two outer sides and close it approximately half way. Pull the door towards you, lifting it out of its slot (see diagram). To replace the door, reverse this sequence.

Inspecting the seals

Check the door seals around the oven regularly. If the seals are damaged, please contact your nearest Service Centre (see Assistance). We recommend that the oven is not used until the seals have been replaced.

!Do not touch the light bulb directly with your hands.

!Do not use the oven lamp as/for ambient lighting.

Automatic cleaning using the FAST CLEAN function

During the FAST CLEAN cycle, the internal temperature of the oven reaches 500°C. The pyrolytic cycle is activated, burning away food and grime residues. Dirt is literally incinerated.

Keep children well away from the appliance during the automatic cleaning cycle, as the surfaces may become extremely hot. Particles may ignite inside the oven due to the combustion process. Particles may ignite inside the oven as a result of the combustion process. This is not a cause for concern; it is a normal process and is completely safe.

Before initiating the FAST CLEAN mode:

!We recommend the duration of the first automatic cleaning cycle is set to 120 minutes.

!The oven should be cold. If the oven is too hot, the pyrolytic cycle may not start. Wait for the oven to cool down.

•Remove larger food residues from inside the oven using a damp sponge. Do not use detergent.

•Remove all accessories.

•Remove the DIVIDER.

•Do not leave tea towels or pot holders on the oven handle.

!The cycle will only begin once the oven door has been closed.

To start the FAST CLEAN cycle, turn the EXTRALARGE

SPACE FUNCTION knob to .

The SET TIME button may be used to select the desired cleaning level. There are three default time settings, which cannot be modified:

1.Economy (ECO): turn the knob towards “ ”. Duration: 1 hour.

2.Normal (NOR): initial level. Duration: 1 hour and 30 minutes.

3.Intensive (INT): turn the knob towards “”. Duration: 2 hours.

4.Press the button to confirm.

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

15