SRP-770II
6. Cleaning Head
Paper dust on the heating elements may lower the printer quality.
When dirty, clean the print head as follows:
※CAUTION
-Make sure to turn the printer power off prior to cleaning.
-As the print head gets very hot during printing, if intending to clean the print head, turn the printer power off and wait approximately 10 minute before commencement.
-When cleaning the print head, take care not to touch the heated portion of the print head.
→The print head is susceptible to damage from static electricity, etc.
-Take care not to allow the print head to become scratched and/or damaged in any way.
1)Open the paper cover and remove paper and ribbon.
2)Wipe the print head with a cleaning pen.
3)Use a cloth moistened with an alcohol solution to clean the paper sensor are and remove any paper remnants and/or dust.
4)Insert paper into the printer 1~2 minutes after completing the cleaning process and close the printer cover.
※Perform the cleaning process each time the paper roll is replaced to prevent print quality deterioration.
Rev. 1.14 | - 23 - |