Primera Technology CX1200 specifications Technical Support

Page 58

TOC INDEX

4.Insert a new image transfer unit back into the printer.

a. Align the guides with the insertion grooves and gently slide the unit in.

Figure 9-9.

b.Rotate the handle up, and push gently to lock the unit in place.

Figure 9-10.

c. Lower the lever to lock the image transfer unit into place.

5.Close the printer door.

6.Turn the printer on. The printer returns to a Ready state.

9.9 Technical Support.

If you have difficulties operating your CX1200, the following additional resources are available.

•Primera Knowledge Base www.primera.com/kb

•Email Support www.primera.com/contactsupport

•Phone Support 763-475-6979 (Mon - Fri 8 a.m. - 5 p.m CST)

54 Maintenance and Troubleshooting

Image 58

Contents Operator’s Guide Ii CX1200 Color Label Press Table of Contents Iv CX1200 Color Label Press Introduction Unpack and Assemble Remove65.5 Kg 140 lbs Unwinder Chuck Rewinder Chuck Left Side Right Side Kg lbs Inches 63.5 mm Important Note Do not touch the exposed ITU TOC Index TOC Index Congratulations! Your CX1200 is setup Install Software Load Label Stock Dancer Arm Cutter Tension Knob TOC Index TOC Index Tensioning Unit Potentiometer Create a Print File Array images with PTPrint WizardTOC Index TOC Index TOC Index TOC Index Manually array images using PTPrint TOC Index Creating Cut Files in PTPrint PLT Import Die LineTOC Index Fill = Fxcut Outline = Transparent Die Cut TOC Index Contour Cut TOC Index TOC Index Cut Settings Label Layout Design Tips Tool OptionsUsing Barcodes Recommended Image format for imported Graphics Toner Monitoring and Supplies Management Estimating Cost Per Label Quote ToolPrinting a Proof Print Labels PerManaging Used Toner Cartridges Enter Supply Roll Length How to use a toner LibraryLow Supplies Warning Other functions of the Status Monitor Media Recommendations Paper TypeOther Warnings Replace Toner Cartridges Troubleshooting and Maintenance Matching Pantone ColorsRecommended Design Procedures Color/Alignment Calibration Print Head AlignmentUse the value closest To the straight line Cut Alignment / Stretch Factor Tip Use a clear acrylic ruler to measure the lines Error Messages Stop/Cut button Replacing the Fuser Replacing the Image Transfer Unit TOC Index Technical Support Specifications TOC Index Index Page Page 511222