Transcend Information 25F user manual Erase Disk confirmation window

Page 19

Figure 19: “Erase Disk” confirmation window

10.Click the “Close” button to finish and exit.

Linux®

1.Plug the StoreJet 25F Ultra into an available USB port on your Linux computer.

2.Unplug all other USB storage devices from your computer. This is to prevent accidental format of a different USB drive.

3.Type fdisk /dev/sda (replace /dev/sda with your actual USB device)

4.Press p

5.Press n

6.Press w

7.Type mkfs.ext3 /dev/sda1

8.Go to /etc/fstab and add: /dev/sda1 /mnt/usbdrive auto user,noauto 0 0

9.Type mkdir /mnt/usbdrive

10.Type mount /mnt/usbdrive

17

Image 19

Contents StoreJet 25F User’s Manual Table of Contents Introduction︱ Quick Start Guide System Requirements︱ General Use Reminders StoreJet 25F Product Overview︱Mini USB to Standard-A USB cable USB Y-cable Connecting to a Computer︱Page Windows 2000, XP and Windows Vista Disconnecting from a Computer︱Linux Kernel 2.4 or Later Windows 2000/XP Formatting the Hard Drive︱Click the Close button to finish and exit Run as administrator Press Start Unreadable drive pop-up window Click Erase again to confirm Erase Disk confirmation window My operating system cannot detect the StoreJet 25F Troubleshooting︱My computer does not recognize the StoreJet 25F StoreJet 25F does not Power-ON Ordering Information︱ Specifications︱Transcend Information, Inc Transcend Limited Warranty︱