RCA RP3755 owner manual FCC Information, Main Connections, Battery Back-Up

Page 1

FCC Information

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

In accordance with FCC requirements, changes or modifications not expressly approved by Thomson multimedia Inc. could void the user’s authority to operate this product.

This device generates and uses radio frequency (RF) energy, and if not installed and used properly, this equipment may cause interference to radio and television reception.

If this equipment does cause interference to radio or television reception (which you can determine by unplugging the unit), try to correct the interference by one or more of the following measures:

Re-orient the receiving antenna (that is, the antenna for the radio or television that is “receiving” the interference).

Move the unit away from the equipment that is receiving interference.

Plug the unit into a different wall outlet so that the unit and the equipment receiving interference are on different branch circuits.

If these measures do not eliminate the interference, please consult your dealer or an experienced radio/television technician for additional suggestions. Also, the Federal Communications Commission has prepared a helpful booklet, “How To Identify and Resolve Radio TV Interference Problems.” This booklet is available from the U.S. Government Printing Office, Washington, DC 20402. Please specify stock number 004-000-00345-4 when ordering copies.

This product complies with DHHS Rules 21 CFR Subchapter J. Applicable at the date of manufacture.

Main Connections

AC OUTLET POWER SUPPLY: 120V ~60Hz

Note:

Power is fed to the unit even when it is not functioning. To cut the power supply off, the power cable must be unplugged.

For Your Safety

The AC power plug is polarized (one blade is wider than the other) and only fits into AC power outlets one way. If the plug won’t go into the outlet completely, turn the plug over and try to insert it the other way. If it still won’t fit, contact a qualified electrician to change the outlet, or use a different one. Do not attempt to bypass this safety feature.

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

Battery Back-Up

This clock radio is equipped with a memory holding system that can be powered with a 9-volt battery (not included). The power failure protection circuit will not operate unless battery is installed.

When normal household power is interrupted, or AC line cord is unplugged, the back-up battery will power the clock radio to keep track of time and alarm settings programmed into memory. When the battery backup functions, the function of alarm still occurs during the power

WARNING: TO PREVENT FIRE OR ELECTRICAL SHOCK HAZARD, DO NOT EXPOSE THIS PRODUCT

T H E L I G H T N I N G FLASH AND ARROW- HEAD WITHIN THE T R I A N G L E I S A W A R N I N G S I G N ALERTING YOU OF

"D A N G E R O U S VOLTAGE" INSIDE THE PRODUCT.

 

CAUTION

 

 

 

 

RISK OF ELECTRIC SHOCK

 

 

 

 

DO NOT OPEN

 

 

 

CAUTION: TO REDUCE THE

THE EXCLAMATION

RISK OF ELECTRIC SHOCK,

POINT WITHIN THE

DO NOT REMOVE COVER

T R I A N G L E

I S A

( O R B A C K ) . N O U S E R -

WARNING

SIGN

SERVICEABLE PARTS IN -

ALERTING YOU OF

S I D E . R E F E R S E RV I C I N G

I M P O R T A N T

T O Q U A L I F I E D S E R V I C E

I N S T R U C T I O N S

PERSONNEL.

A C C O M P A N Y I N G

 

 

 

T H E P R O D U C T .

 

 

 

 

 

interruption if remaining battery power is adequate. Normal operation will resume after AC power is restored so you will not have to reset the time or the alarm. With battery back-up, if Wake to Radio or Wake to CD is activated during power interuption, Wake to Tone will operate instead. Wake mode will operate normally again once power is resumed.

When AC power is interrupted (disconnected) for a short period of time, both time and alarm settings will change (unless optional battery is installed). After AC power is restored

TO RAIN OR MOISTURE.

SEE MARKING ON BOTTOM / BACK OF PRODUCT

(reconnected), the Digital Display will blink to indicate that power was interrupted and you should readjust the time and alarm settings.

Caution

Service

This product should be serviced only by those specially trained in appropriate servicing techniques. Attach your sales receipt to the booklet for future reference or jot down the date this product was purchased or received as a gift. This information will be valuable if service should be required during the warranty period.

Purchase Date _________________________

Name of Store ________________________

Have a Blast- Just Not in Your Eardrums!

Make sure you turn down the volume on the unit before you put on headphones. Increase the volume to the desired level only after headphone are in place.

The descriptions and characteristics in this owner’s manual are for the purpose of general reference only and not as a guarantee. In order to provide you with the highest quality product, we may make changes or modifications without prior notice. The English version serves as the final reference on all product and operational details should any discrepancies arise in other languages.

RP3755 EN-US rev.2

2-3

6/21/01, 2:37 PM

Image 1
Contents FCC Information Battery Back-UpMain Connections Setting Wake to Tone Setting timeDigital CD Clock Radio DisplaySetting Wake to CD Setting Wake to RadioTo tune to your desired station REV or FWDSetting Countdown Timer Adjusting snooze durationStopping alarm Setting NAP DurationRadio Frequency Memory Listening to radioAutomatic Station Search Memory RecallSleep to CD/radio Listening to compact discPress Skip REV or FWD Press PLAY/PAUSEWarranty Care and MaintenanceE r m a n