RCA RP3755 owner manual Digital CD Clock Radio, Setting time, Display, Setting Wake to Tone

THE DIGITAL CD CLOCK RADIO

Protection against main power failures:

1. Remove battery compartment door (located on the bottom of the radio) by

applying thumb pressure to area indicated on battery door and then lift the door

out and off the cabinet.

THE DIGITAL CD CLOCK RADIO

SET

Press SET CLOCK WAKE CLOCK/WAKE repeatedly to scroll between SET CLOCK, SET

WAKE1, SET WAKE2 and LOCK.

Setting time

2.	Connect a 9-volt battery connector plug. (6LR61 or NEDA 1604A)
3.	Insert battery in the compartment and replace the compartment door.

NOTE: Alkaline (6LR61/NEDA 1604A) batteries are recommended. Carbon-zinc battery may be used but memory holding time will be substantially reduced. Memory holding time for a fresh alkaline battery is approximately 8 hours (if radio or alarm are not operated) which

			<<	S ET		>>
		WAKE 2	RE	CLOC	K/W
	CANCEL		V		AKE	FWD	TIMER
WAKE 1								S LEEP
PHONES

OPEN

1

2

SET

Press SET CLOCK/WAKE CLOCK/WAKE.

will appear on the display.

<<	>>
Press REV REV	or FWD FWD

to select current time while the clock icon is displayed.

should take care of short, nuisance-type AC power failures. To preserve battery life, the unit should remain plugged into an AC outlet. As the battery gets older, its voltage drops and memory may be lost. Be sure to replace the battery periodically. Battery should be removed if the unit will be stored for more than one month. Leaky battery can badly damage the clock radio.

The Display

	Wake
	to Radio	Wake	Random
Wake		to CD	playback

NOTE:	<<		>>
1. Press and hold REV	REV	or FWD	FWD
			to skip fast

2.The time display has a 12-hour format. AM/PM indicator will light to show AM or PM time respectively.

AM

PM

Setting Wake to Tone

	to Tone					Clock Setting
Wake 1	WAKE 1	1	1	1	ALL	TIMER	TRACK	Track number and
Wake 2	WAKE 2	2	2	2	CDFM		AM	radio preset number
							MEMO	Function
	AM							indicator
AM/PM							STEREO
								Memory
indicator	PM						MHz
							KHz	Stereo
	Repeat All							Radio frequency
	indicator							scale

					<<	S ET	>>
					REV	CLOC K/W
WAKE	1	CA	NCEL	WAKE 2		AKE	FWD
PHONES

OPEN

TIMER S LEEP

Press WAKE 1 WAKE 1 to select wake to

1 Alarm. 1 indicator will light to show selection.

SET

2Press SET CLOCK/WAKE CLOCK/WAKE . WAKE 1 will appear on the display.

<< >>

3Press REV REV or FWD FWD to set the

wake time.

Countdown/Nap/

Timer indicator

1

1.With the GRADUWAKE feature, the alarm tone volume will increase gradually to its maximum in about 30 to 45 seconds.

2.You cannot adjust the alarm tone with volume.

2

RP3755 EN-US rev.2 4-5

6/21/01, 2:38 PM