American Power Conversion 450 user manual Initial Inspection, Installation

Page 7

Initial Inspection

Inspect the APC PowerStack 450 UPS upon receipt. Notify the carrier and dealer if there is damage. The packaging is recyclable; save it for reuse or dispose of it properly.

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void

the warranty.

Installation

Placement

Install the UPS in a protected area that is free of excessive dust and has adequate air flow. Do not operate the UPS where the temperature and humidity is outside the specified limits.

Wall Mounting

The brackets on the UPS can be rotated 90° for wall mounting. Remove the screws, rotate the brackets, and insert the screws in the appropriate holes. Wall-mount the unit with the controls towards or at the top, not at the bottom of the unit. The illustrations immediately below show the proper positions for wall mounting the unit.

Warning!

Do not mount the unit on the wall as shown in the illustrations below. Doing so

could result in a safety hazard.

Desktop Use

This UPS is provided with four adhesive-backed rubber “feet” for desktop use. Attach the feet to the bottom of the unit and remove the ears to use it on a desktop.

The recommended placement of the feet is shown by a small + on the bottom corners of the unit:

Front of Unit

Bottom of Unit

Rack Mounting

The UPS comes with standard 19” (46.5 cm) rack mount brackets. It is supplied with four (4) screws to attach the mounting brackets (ears) to the chassis.

Select a rack location with adequate air flow that is free from excessive dust. Ensure that the air vents on the sides of the UPS are not blocked. Do not operate the UPS where temperature or humidity are outside the limits listed in Specifications, page 9.

3

990-5022A, Revision 2 6/99

Image 7
Contents 990-5022A, Revision 2 6/99 Connect Equipment Install UPSTurn on UPS Table of Contents Page Electrical Safety SafetyHandling Safety Page Initial Inspection Installation990-5022A, Revision 2 6/99 Computer Interface Port SetupBattery Pack Charge Operating InstructionsOverload LEDs and Audible AlarmsOn Battery Replace BatteryStorage Operating ModesReplacement Batteries Replacing the Battery PackBattery Pack Replacement Procedure Service SpecificationsAPC Japan Contact Information Limited Warranty