APC 750 user manual 92VAC

NOTE: SETTINGS ARE MADE THROUGH SUPPLIED POWERCHUTE SOFTWARE OR OPTIONAL SMART SLOT

ACCESSORY CARDS.

FUNCTION		FACTORY		USER SELECTABLE		DESCRIPTION
		DEFAULT		CHOICES
Low Battery Warning.			Brightly lit: Low battery			The low battery warning
PowerChute interface			warning interval is about			beeps are continuous when
			two minutes.			two minutes of run time re-
software provides auto-
			Dimly lit:		Low battery	main.
matic, unattended shut-
			warning interval is about			You can change the warning
down when approximately
			five minutes.
two minutes (by default) of						interval default setting
			Off:		Low battery
battery operated run time						through PowerChute soft-
			warning interval is about
remains.						ware.
			eight minutes.
			Possible interval settings:
			5, 7, 10, 12, 15, 18 min-
			utes.
Synchronized Turn-on	0 seconds		20, 60, 120, 240, 480,			The UPS will wait the speci-
Delay			720, 960 seconds			fied time after the return of
						utility power before turn-on
						(to avoid branch circuit over-
						load).
High Transfer Point	100V:		100V:			To avoid unnecessary battery
	108VAC		110, 112, 114VAC			usage, set the high transfer
	120V:		120V:			point higher if the utility volt-
						age is chronically high and
	127VAC		130, 133, 136VAC			the connected equipment is
	230V:		230V:			known to work under this
						condition.
	253VAC		257, 261, 265VAC
Low Transfer Point	100V:		100V:			Set the low transfer point
	92VAC		86, 88, 90VAC			lower if the utility voltage is
	120V:		120V:			chronically low and the con-
						nected equipment can tolerate
	106VAC		97, 100, 103VAC			this condition.
	230V:		230V:
	208VAC		196, 200, 204VAC

8