APC 750 user manual Operation

Page 7

2:OPERATION

SMART-UPS FRONT PANEL

Power On

Power Off

Online

The online LED illuminates when the UPS is supplying utility power to

 

the connected equipment. If the LED is not lit, the UPS is either not

 

turned ON, or is supplying battery power.

AVR Trim

AVR Boost

On Battery

Overload

This LED illuminates to indicate the UPS is compensating for a high utility voltage.

This LED illuminates to indicate the UPS is compensating for a low utility voltage.

When the on battery power LED is lit the UPS is supplying battery power to the connected equipment. When on battery, the UPS sounds an alarm—four beeps every 30 seconds.

The LED illuminates and the UPS emits a sustained alarm tone when an overload condition occurs.

5

Image 7
Contents APC Smart-UPS Page Introduction Rail InstallationUnpacking Mounting the UPS in a Rack Positioning the UPSConnecting Equipment and Power to the UPS UPS. Use only interface kits supplied or approved by APC Operation On Battery Operation User Configurable Items 92VAC Disconnecting the Battery for Transport Replacing the Battery ModuleStorage Troubleshooting 120V models only. Site wiring Utility Voltage Contacting APC ServiceRegulatory Agency Approvals and Radio Frequency Warnings Declaration of Conformity Limited Warranty