Anti-Blocking Switch ABS, Trimming function

➩If you do not want to start another lamination process, turn the foil thickness switch o to ABS (OFF) and withdraw the plug from the mains power socket.

➩Hold the paper in a secure position with your left hand.

➩To trim, press the cutting head e down with the right hand and then slide it with one pull or push over the document.

11. Anti-Blocking Switch (ABS)

At the start of the lamination process, the pouch may be pulled in at an angle or jam itself inside the appliance.

➩Turn the anti-blocking switch (ABS) o to the position ABS.

•The laminate pouch is not pulled any further in.

➩Remove the laminate pouch.

➩Turn the anti-blocking switch (ABS) o back to the desired foil thickness.

➩Re-start the lamination process.

12. Trimming function

Should you wish to use the trimming function on the pouch guide q, dismantle the pouch guide q.

➩If necessary, fold the documents supports s down.

➩Adjust the cutter attachment d so that it forms a straight face with the foil guide rails q.

➩Slide the cutting head e to the end stop (the cutting head e can be slid to both ends of the cutting rail w).

➩Flap the cutting rail w upwards with the rounded grip and position the document on the pouch guide q. Restrain the document by sliding the pouch format locks r together until they touch both sides of the document.

➩Use the markings on the measurement table to align the document precisely.

➩Flap the cutting rail w downwards so that it engages.

13.Cleaning and care

Potentially fatal electrical shock:

•Never open the appliance housing. There are no user-serviceable elements inside.

•Never submerse the appliance into water or other liquids!

Cleaning the housing:

Clean the surface of the housing with a slightly moistened cleaning cloth.

➩First remove the plug.

➩Allow the appliance to cool down completely.

➩Ensure that no moisture can permeate into the appliance.

Cleaning the interior of the appliance:

With every lamination, contaminants are deposited on the rollers inside the laminator. Over time, this re- duces the performance of the laminator. You should therefore clean the rollers inside the laminator after use.

➩Prepare the appliance as described in Chapter 8 "Preparing for hot lamination", up to the point where the green indicator lamp "Ready" y glows.

- 7 -