OPERATIONAL CONTROL PANEL
The Control Panel (see Figure 3) is lo- cated on the top right of the machine. A diagram of the Control Panel is shown in Figure 2.
Figure 2
The | of the rollers is controlled in |
the | section of the Control Panel. |
1. To | the rollers on, press the |
| pad once. The Green LED |
| will turn on indicating the bot- |
| roller is turning. Note: the top |
| is free spinning as with all high |
| laminators. The PHOENIX will |
| be set to the faster |
| speed. |
2.To adjust the speed of the rollers, press the ‘Rabbit’ for the faster speed (approximately 1 foot per minute) or the ‘Turtle’ (approximately 6 inches per minute) for the slower speed. All standard pouches and pouch boards with inkjet paper up to 11 mils thick should work on the faster speed. For thicker materials.use the slow ‘Turtle’ speed. The LED light which is on is the current speed of the PHOENIX.
Figure 3
Location of Control Panel
Heat Control
The Heat of the rollers is controlled in the section of the Control Panel. When you the PHOENIX on, the heat will be off and
the cold. The LED Light above the switch will be the color red.
1. To | heat on, press the ‘On/Off’ | |
pad once. | LED above the ‘On/Off’ | |
the | will automatically be set to | |
the ‘Pouch’ | setting and the ‘Pouch’ | |
LED will be lit. | LED above the ‘On/ | |
Off’ switch will be | indicating the | |
roller is heating. | that light be- | |
comes yellow, the | is ready to | |
process your pouch |
| |
2.To adjust the heat of the rollers, press the ‘Pouch’ button when using pouch boards, mounting boards or flexi- ble pouches. The ‘Pouch’ heat setting is the higher setting and has a roll face temperature of 150° Celsius. The Roll temperature is a lower 90° Celsius (195° Fahrenheit) for use with standard inkjet laminating films.
In case of Emergency: Turn off the main power switch or unplug the machine from the power outlet. Open the Roller Gap Control to its fully open position and remove your work.
PHOENIX 44 LAMINATOR | 9 |
|
|