Royal Sovereign 1650C, RSC-1650H owner manual Hanging Film

Page 7

HANGING FILM

TAKE UP DEVICE

PAPER BACK HOT ROLLER

PAPER BACK

COLD FILM

UPPER IDLE BAR

LOWER IDLE BAR

1. Set up cold film below the upper bar of the machine.

(Set the same as methord of the HOT film for protect paper of lower part)

2.Set the pressure lever to the 15mm, open mode.

3.Insert a piece of wide cardboard (guiding paper/carrier) between the rollers.

4.Pull the film from the upper roller passing over the upper idle bar to the upper roller and put it on the upper roller.

5. Put the paper back of the film to the bobbin at take-up bar to rewind the paper back.

6.Allow some of the film with melted resin to stick to the Guiding Paper.

7.Place the film from lower shaft beneath the film from the upper roller which is already meiting. and unwind films of both rollers 30~40cm(1~1.3ft) for loosing the tension.

8.Set the pressure lever to the 1mm.

9.Set speed at 1 and press the RUN button. The films will be fed into the machine and will come out from the rear site of machine.

10.Check the status of lamination and place the pressure lever at lamination mode.

- 7 -

Image 7
Contents Royal Sovereign Laminators Table of Contents Instruction Safety PrecautionsSpecifications CharacteristicDescription Upper Roller Names of Major Parts of MachineCold Film Paper Back Setting UP FilmHanging Film Methods of controlling pressure of the roller Control of Roller PressureTerms Instructions for Control PanelFunctions of Control Panel HOW to USE ButtonsReference Laminating StepsCross Cutter Method for Using CutterMaintenance Important Safety ConcernsIts not out of order Assembly PartsWarranty
Related manuals
Manual 9 pages 60.52 Kb