Specifications
| GBC HeatSeal H520 |
| |
|
|
Electrical | 230V / 50Hz / 2.5A / 600W |
Machine Dimensions | 550 x 190 x 114mm |
|
|
Machine Weight | 6.3kg |
|
|
Maximum Pouch Width | 320mm |
Minimum/Maximum Pouch Thickness | 2 x 75 mic (Total 150) / 2 x 175 mic (Total 360) |
Maximum | 1mm |
|
|
5 minutes | |
|
|
Speed | 800mm per minute |
Safety instructions | m |
YOUR SAFETY AS WELL AS THE SAFETY OF OTHERS IS IMPORTANT TO ACCO BRANDS EUROPE. IN THIS INSTRUCTION MANUAL AND ON THE PRODUCT ARE IMPORTANT SAFETY MESSAGES. READ THESE MESSAGES CAREFULLY.
mTHE SAFETY ALERT SYMBOL PRECEDES EACH SAFETY MESSAGE IN THIS INSTRUCTION MANUAL.
THIS SYMBOL INDICATES A POTENTIAL PERSONAL SAFETY HAZARD THAT COULD HURT YOU OR OTHERS, AS WELL AS CAUSE PRODUCT DAMAGE OR PROPERTY DAMAGE.
THIS WARNING IS FOUND ON THE PRODUCT.
cmWARNING
Electrical shock hazard.
Do not open. No user servicable parts inside. 
Refer servicing to qualified service personnel.
This safety message means that you could be seriously hurt or killed if you open the product and expose yourself to hazardous voltage.
Special notice
Thank you, for your recent purchase of a GBC Pouch Laminator. Your new laminator may emit a slight odour during the initial stage of operation. It is normal and will diminish after several hours of operation.
Cleaning
mCaution: Unplug this product before cleaning.
•Wipe exterior only with a damp cloth. Do not use detergents or solvents.
•Do not use aerosol dusters or cleaners
•Do not spray anything into the product, foreign substances can be explosive.
Service
•Do not attempt to service or repair the pouch laminator yourself. Unplug the unit and contact an authorised ACCO Brands Europe service representative for any required repairs.
Important safeguards | m |
mWARNING: FOR YOUR PROTECTION DO NOT CONNECT THE POUCH LAMINATOR TO ELECTRICAL POWER UNTIL YOU READ THESE INSTRUCTIONS COMPLETELY. KEEP THESE INSTRUCTIONS IN A CONVENIENT LOCATION FOR FUTURE REFERENCE. TO GUARD AGAINST INJURY, THE FOLLOWING BASIC SAFETY PRECAUTIONS MUST BE OBSERVED IN THE
General safeguards
•Use the unit only for its intended purposes of laminating documents.
•Do not place anything in the throat opening of the laminator other than pouches/documents.
•Place unit on a secure, stable work area to prevent the unit from falling and possibly causing personal injury and damage to the unit.
•Follow all warnings and instructions marked on the unit.
•The socket outlet shall be installed near the equipment and shall be easily accessible.
•Do not block the vent slots, this will cause the laminator to overheat.
•Never insert the loose end of the pouch first into the machine. This could cause the machine to jam.
•Never attempt to do single sided lamination. This will cause the machine to jam.
•After laminating run a clean card through the machine to clean glue residue off of the rollers. This will extend the life of the rollers.
Electrical safeguards
•The unit must be connected to a supply voltage corresponding to the electrical rating shown on the unit.
•Unplug the unit before moving it, or when it is not in use for an extended period of time.
•Do not operate with a damaged supply cord or plug. Do not alter the attachment plug. The plug is configured for the appropriate electrical supply.
•Do not overload electrical outlets beyond their capacity; fire or electrical shock could result.
•The unit is intended for indoor use only.
•Do not spill liquid of any kind on this product.
•Close supervision is required when this product is used near children.