3.Lift each of the image drum units out of the printer and place them in a safe place away from direct sources of heat and light.
CAUTION!
The green image drum surface at the base of each cartridge is very delicate and light sensitive. Do not touch it and do not expose it to normal room light for more than 5 minutes. If the drum unit needs to be out of the printer for longer than this, please wrap the cartridge inside a black plastic bag to keep it away from light. Never expose the drum to direct sunlight or very bright room lighting.
4.Locate the two fasteners (5) at each side of the belt and the lifting bar (6) at the front end.
5
6
5.Turn the two fasteners 90° to the left. This will release the belt from the printer chassis.
6.Pull the lifting bar (6) upwards so that belt tilts up towards the front, and withdraw the belt unit from the printer.
7.Lower the new belt unit into place, with the lifting bar at the front and the drive gear towards the rear of the printer. Locate the drive gear into the gear inside the printer by the rear left