Tear off the sticker | Fix the arm on the 11.5cm right far from Tear off the sticker | |||
| you printer | |||
|
|
|
|
|
|
|
|
|
|
Fix the balance arm | Tear off the sticker of clamp | Attached the clamp on your printer |
|
| and let it parallel with printer |
5)Fiveth step : Install tubeline
Insert tubelline through the arm | Finished |
6) Sixth Step: Adjust the tubeline
Adjust the tubeline,remove the | Make sure tubline will not meet | Make sure the lengh of tubline is |
printer when printing | enough to reach the far left and right |