Important Safety Information
This section presents important information intended to ensure safe and effective use of this product. Read this section carefully and store it in an accessible location.
Key to Symbols
The symbols in this manual are identified by their level of importance, as defined below. Read the following carefully before handling the product.
WARNING:
Warnings must be followed carefully to avoid serious bodily injury.
CAUTION:
Cautions must be observed to avoid minor injury to yourself, damage to your equipment, or loss of data.
Note:
Notes have important information and useful tips on the operation of your equipment.
Safety Precautions
WARNING:
Shut down your equipment immediately if it produces smoke, a strange odor, or unusual noise. Continued use may lead to fire or shock. Immediately unplug the equipment and contact your dealer or a Seiko Epson service center for advice.
Never attempt to repair this product yourself. Improper repair work can be dangerous.
Never disassemble or modify this product. Tampering with this product may result in injury, fire, or shock.
Be sure to use the specified power source. Connection to an improper power source may cause fire.
Never insert or disconnect the power plug with wet hands. Doing so may result in severe shock.
Do not place multiple loads on the power outlet (wall outlet). Overloading the outlet may lead to fire.
Be sure your power cord meets the relevant safety standards and includes a
Handle the cables with care. Improper handling may lead to fire or shock. Do not use the cables if it they are damaged.
Do not modify or attempt to repair the cables. Do not place any object on top of the cables.
Avoid excessive bending, twisting, and pulling of the cables. Do not place cables near heating equipment.
Check that the plug is clean before plugging it in.
Check that the AC inlet is clean before plugging the power connector in it. Be sure to push the prongs and power connector all the way in.
Use the provided power cable only. Do not use the provided power cable with any other devices than the specified one. Doing so may lead to fire or shock.
Never glue the AC inlet and the power cable together.