tem battery.
WARNING: Always protect this power wire by installing a fuse or circuit breaker of the appropriate size within 12 inches of the battery terminal connection.
3.REM - this terminal turns on the amplifier when (+) 12 volt is applied. Connect it to the remote turn on lead of the head unit or signal source. If a (+) 12 volt remote turn lead is not available, a Remote Power Adapter (P/N #55000) can be used to supply a remote turn on signal. DO NOT connect this terminal to constant (+) 12 volt.
4.GND - power return connection. Connect this terminal directly to the sheet metal chassis of the vehicle, using the shortest wire necessary to make this connection. Always use wire of the same gauge or larger than the (+) 12 volt power wire. The chassis connection point should be scraped free of paint and dirt. Use only quali- ty crimped and/or soldered connectors at both ends of this wire. DO NOT connect this terminal directly to the vehicle battery ground terminal or any other factory ground points.
5.Speaker - connect the speakers to these terminals. (refer to the Speaker Connection section of this guide.)
NOTE: Make all connections to power, ground, speakers, and remote terminals before final positioning and installation of the amplifier in the vehicle.
CEA SPECIFICATIONS
HCCA-D600
Power Output: 150 Watts RMS x 1 at 4 ohms and < 1% THD+N
Signal to Noise Ratio:
Additional Power Output: 300 Watts RMS x 1 at 1 ohm at 14.4 Supply <1% THD+N
© 2005 Directed | 5 |