Canon manual Canon imageRUNNER Knowledge Module for Patrol

Page 12

2.In the Discovery Settings dialog box, under Search Preferences, select how you want to discover newly added Canon printers.

3.If you selected Ping SNMP, under Enter IP Address range, specify the range of IP addresses to ping.

4.To set the discovery process to run automatically, based on your defined settings, click Auto Discovery.

If you clicked Auto Discovery, specify the time interval to refresh the discovery of Canon printers.

5.To set the discovery process to detect only IP devices, excluding any IPX devices, click Discover IP Devices Only.

10 Canon imageRUNNER Knowledge Module for PATROL

Image 12

Contents Canon imageRUNNER Knowledge Module For Patrol Copyright Canon imageRUNNER Knowledge Module for Patrol Introduction Supported Canon PrintersSupported Network Protocols About This GuideConventions Used in This Guide Before You Begin Installing Canon KM System RequirementsInstalling the Canon KM Software To install the Canon KM softwareTo load the Canon printer knowledge module Uninstalling Canon KM To unload the Canon printer knowledge moduleMonitoring Your Printer Status To remove the Canon KM softwareTo reboot a printer Performing Printer TasksTo display the copyright and version for Canon KM To refresh the printer parametersDefining Discovery Settings To enable the display of debug messages for all printersTo define Discovery settings Canon imageRUNNER Knowledge Module for Patrol Specifying the Search Preference Broadcast SnmpPing Snmp Specifying IP Addresses to Ping Specifying Discovery of IP Devices OnlyTo add a range of IP addresses To edit a range of IP addressesDiscovering Non-Canon Devices Managing a Maximum Number of DevicesManually Starting and Stopping the Discovery Cycle Appendix Technical Notes Parameter DescriptionIndex Index