Starting the Installation Procedure
Important! If you have a previous version of the MultiPASS Desktop Manager installed, you must use the MultiPASS Uninstaller to remove it before beginning installation of the MultiPASS L6000. See your User's Manual for details.
1
Start up your system in this order.
It's important to follow this order for the Windows 95 Plug and Play feature to work:
1.Make sure your computer is turned OFF.
2.Be sure the MultiPASS L6000 is plugged in and connected to the computer.
3.Now turn on the computer.
2
Make sure Windows 95 starts.
Be sure to wait for Windows to complete each operation.
If Windows recognizes the MultiPASS:
You see a screen similar to this:
*
If the "New Hardware Found" dialog box does not appear:
Insert the
Install Me First CD into your CD drive.
If AutoRun is enabled, installation starts immediately. (Go to step 3 on the next page.)
Insert the Install Me First CD into your CD drive.
Make sure “Driver from disk provided by hardware manufacturer” is selected and click OK.
You see this screen:
In this box, type D:\ (where D:is your CD drive... most CD drives are either D:or E:). Make sure the Install Me First CD is in your CD drive and then click OK.
*If this is not the screen you see (instead you see the Update Device Wizard), please see the Installation slip sheet that came in the box for instructions.
If installation doesn’t start, from the taskbar, click Start and then Run.
You see this screen:
In this box, type D:\SETUP (where D:is your CD drive...
most CD drives are D:or E:). Then click OK.
17