Monitor Audio GS LCR owner manual Your Gold GS FX, 106

Page 6

Your Gold GS FX

The new GSFX is a completely new design from Monitor Audio. A combined di-pole and monopole speaker for use in high-end or professional cinema applications.

In monopole mode the front firing RST®2 bass/ mid-range and C-CAM®tweeter provide an accurate full-bandwidth sound-field for use in multiples or as a rear effect. In di-pole mode the side firing drivers (one set at each end), combined with the tailored output from the front firing driver, to provide a diffused sound-field for use as a pure effect speaker in a more advance installation. The di-pole drivers have also been design to be a 2-way compliment incorporating a 4” C-CAM®bass driver and 25mm C-CAM®gold dome tweeter. When in dipole mode the front tweeter is disconnected, and the crossover frequency of the main driver lowered.

To remove the grille, carefully prize it away from the cabinet using you fingers. The main grille locates in the elongated holes around the outside of the driver chassis. To replace it, line the peg fixings (in the grille) up with the elongated holes and gently press into place. The side grilles locate in recessed grommets in the cabinet itself. These can be a very tight fixing.

For system set up please see positioning ideas on pages 7 and 8.

 

 

 

 

 

 

 

Maximum

 

Power

 

Recommended

 

Bass

 

Frequency

Sensitivity

 

Nominal

 

 

 

 

Amplifier

 

 

Response

(1W@1m)

 

Impedance

S.P.L (Per pair in

Handling

 

power output.

 

Alignment

 

 

 

 

 

(ohms)

 

room). dBA

 

RMS (W)

 

 

(W)RMS

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

60Hz –

 

86dB

 

6

 

 

106

 

100

 

 

40 – 100

 

Sealed

 

43KHz

 

 

 

 

 

 

 

 

Enclosure

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Tweeter

 

Bass

 

 

 

 

 

External

 

External

 

 

 

 

 

Drive Unit

Dimensions -

 

 

 

crossover

 

Crossover

 

 

Dimensions -

Weight kg (lb)

 

frequency

 

Frequency

 

Complement

Excluding plinth

 

Including plinth

 

kHz

 

Hz

 

 

 

 

 

W x H x D

 

mm (inch)

 

 

 

 

 

 

 

 

mm (inch)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1 x 6” RST®2

 

 

 

 

 

 

 

 

 

 

 

 

 

Bass/ Mid mono-

 

 

 

 

 

 

 

 

2.7

 

 

 

 

 

pole driver

 

 

 

 

 

 

11.5 / (25.3)

 

 

N/A

 

 

1 x 25mm Gold

 

310 x 390

 

N/A

 

 

 

 

 

 

 

Dome C-CAM®

 

x 160

 

 

 

 

 

 

 

 

 

 

 

tweeter, 2 x 4”

 

(12 3/16”

 

 

 

 

 

 

 

 

 

 

C-CAM®mid di-pole

 

x 15 3/8”

 

 

 

 

 

 

 

 

 

 

drivers, 2 x 25mm

 

x 6 5/16”)

 

 

 

 

 

 

 

 

 

 

Gold Dome C-CAM®

 

 

 

 

 

 

 

 

 

 

 

 

 

di-pole tweeters

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

© Monitor Audio Ltd 2005

 

 

 

4.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

V2

 

 

 

 

 

 

 

 

Image 6
Contents GS FX & GS LCR Contents Introduction Water & Moisture CleaningRead Instructions HeatYour Gold GS LCR WrmsYour Gold GS FX 106Setting up the GS FX Optimum Performance Volt Trigger Front Panel Switches Location SwitchMonopole/ Dipole Switch Positioning System Example large System Example small Page Fixing Your GS FX to a Wall Connecting Your Gold GS Loudspeakers Guarantee and Service Claims under this GuaranteeCustomer Service Data Protection Owner InformationDealer Details Moisten Here England