Brady 200M-e 300 manual 0HGLD6SHFLILFDWLRQV, Media Specifications 200M-e/200M-e

0HGLD￿6SHFLILFDWLRQV

Media Specifications			200M-e/200M-e 300
		Tear-off	0.7" (18 mm)
Minimum label length*		Peel-off	0.5" (13 mm)
		Cutter	1.5" (38 mm)
		Rewind	0.25" (6 mm)
		Minimum	0.79" (20 mm)
Total media width (label + liner, if any)
		Maximum	4.52 mm (115 mm)
		Minimum	0.003" (0.076 mm)
Total thickness (includes liner, if any)
		Maximum	0.012" (0.305 mm)
Cutter maximum full-width media thickness			0.009" (.23 mm)
Roll media core inside diameter			3" (76 mm)
Maximum roll diameter			8.0" (203 mm)
		Minimum	0.079" (2 mm)
Inter-label gap		Preferred	0.118" (3 mm)
			Maximuminter-labelgap=
		Maximum	2 x (label length for which you have
			calibrated the printer) + 1"
Maximum internal fanfold media pack size (label + liner)			8.0" x 4.5" x 4.5"
L x W x H			(203 mm x 114 mm x 114 mm)
Ticket/tag sensing notch L x W			0.12" x 0.25" (3 mm) x (6 mm)
Ticket/tag sensing hole diameter			0.125" (3 mm)
	Mark length	Minimum	0.12" (3 mm)
	(measuring parallel to
		Maximum	0.43" (11 mm)
	label/tag edge)
	Mark width (measuring	Minimum	≥ 0.43" (≥ 11 mm)
	to perpendicular label/
Additional specifications for		Maximum	Full media width
	tag edge)
black mark sensing
	Mark location		Marks must be located within 0.040" (1 mm)
			of the inside media edge.
	Mark density		>1.0 Optical Density Unit (ODU)
	Maximum density of the back of the media
	on which the black mark is printed		0.5 ODU

*Media registration and minimum label length are affected by media type and width, ribbon type, print speed, and printer mode of operation. Performance improves as these factors are optimized. Brady recommends always qualifying any application with thorough testing.

88 Bradyprinter 200M-e and 200M-e 300 User’s Guide