POWER SUPPLY INFORMATION
(NON INTERNAL POWER SUPPLY MODELS)
Panasonic recommends using a Lind Auto Adapter (Lind part number PA1580-2961) to power the docking station. It can be ordered from Gamber-Johnson (part number 14103) or directly from Lind Electronics, Minneapolis, Minnesota (952-927-6303).
Installation of the Power Jack:
Remove the #8-32 screw and the Power Cable Cover on the bottom of the dock (Figure 4). Attach the Power Cable Pull Strap (located in the hardware bag) to the power jack as shown (Figure 5). Plug the power jack into the input jack, located on the port replicator circuit board inside the docking station, and tuck the pull strap into the docking station as shown (Figure 6). Replace the Power Cable Cover to secure the power jack (Figure 7).
Figure 4 | | Figure 5 |
Remove #8-32unc screw | | | | Power Cable Pull Strap |
| |
and Power Cable Cover | | |
Figure 6
Insert power jack into mating jack on port replicator board and tuck the pull strap into the electrical box.
Figure 7
Replace Power Cable Cover
to hold the power jack in place.
