Diversity Wireless by Anchor Audio

Anchor Audio UHF wireless is a 16 channel, diversity wireless system that receives signals with two independent antennae. With diversity wireless the receiver processes the stronger signal, effectively minimizing dropouts and interference from other transmitting sources. The antennae are mounted internally so there are no obstructions or risk of damage.

CARING FOR YOUR BUILT-IN BATTERIES

It is very important that you fully charge the batteries in your new sound system before the first time its used. To preserve battery life it is also recommended that batteries be fully charged as soon as possible after every use regardless of the length of operation.

CHANNEL SELECTION - BUILT-IN RECEIVER

Select a channel, set the built-in receiver and micro- phone transmitter to that channel before using your wireless system.

1.Choose any available wireless channel/ frequency from 1 thru 16 (transmitter instructions - page 7)

2.Set the Wireless Channel Selector Knob to the channel/frequency you choose in step 1 above

Remember, to operate the receiver & transmitter pair must be set to the same channels.

WIRELESS MICROPHONE			WIRELESS RECEIVER CHANNEL
VOLUME CONTROL			SELECTION KNOB

UNDERSTANDING THE BATTERY LEVEL INDICATOR LIGHT

LED Flashing Red	Battery charge is very low, in 15-30 minutes the Battery Protection Circuit will turn the system off
LED Off	Battery is completely drained and must be charged

NOTE: System Can Be Used When Batteries Are Being Charged!

OPERATING ACCLAIM IN AC MODE

Plug your sound system into an AC outlet and operate as normal while charging the built-in batteries at the same time. The Charger LED will light during charging and flash when the battery is fully charged.

BATTERY SERVICE TIME

With the batteries fully charged you can expect approx.:

6-8 hrs @ Medium Volume

2-4 hrs @ Full Volume

RX INDICATOR LIGHTS

NOTE: Ongoing wireless interference? The frequency you selected may be in use by

other systems in the area! Change channels until you find a clear frequency!

NEED MORE HELP? View demonstration videos on proper system setup and operation:

www.anchoraudio.com

Of continuous music input (longer for speech). However service time will vary depending on control settings and the use of accessories (built-in CD player, wireless receivers and/or a companion speaker).

IMPORTANT: Always Store Your System w/ Batteries Fully Charged!

SYSTEM STORAGE & BATTERIES

Always store your sound system with the batteries fully charged. For extended periods of storage leave the system plugged into an AC outlet. If this is not possible, charge the system at least once each month for a minimum of 24 hours.

ACCLAIM Accessories

AN-1001X - Companion Speaker

Unpowered companion speaker (speaker cable not included)

SC-50 - Heavy Duty Speaker Cable

50’ speaker cable, connect AN-1001X to powered Acclaim

SS-550 - Heavy Duty Speaker Stand

Adjustable stand made of black, anodized aluminum

ACC-BASE - Base for Acclaim

Acclaim lectern base & traveling case

MIC-90 - Handheld Wired Microphone

Anchor’s dynamic, balanced, low impedance microphone w/ unidi- rectional pick-up pattern, mic “on/off” switch & 20’ cable

BATTERY LEVEL

INDICATOR LIGHT

CHARGER

INDICATOR LIGHT

ANCHOR WIRELESS - 16 CHANNEL UHF

WH-6000 - Handheld Microphone/Transmitter	WB-6000 - Body Pack Transmitter
Wireless transmitter & microphone in one unit	Works w/ hands free microphones (mic not included)
Body Pack Transmitter Microphones:
CM-60 - Collar Microphone	LM-60 - Lapel Microphone
Lightweight, low-profile mic	Lightweight, clip-on lapel mic
EM-60T - UltraLite Microphone	HBM-TA4F - Headband Microphone
Hands free “Over-the-Ear” mic	Ultra-lightweight headband mic

CHARGING YOUR BUILT-IN BATTERIES

An automatic charging system is built-in to your Acclaim Lectern Sound System. It is designed to properly charge and maintain the systems built-in batteries. To charge the batteries:

1.Plug the power cord into your sound system

2.Plug the other end of the cord into AC outlet (Charger LED will stay on during charging)

3.Batteries will be fully charged in approximately 6-8 hrs (Charger LED will flash)

When in AC mode the system automatically transfers power from the battery charger to the power amplifier at high volume output, causing the Charger LED to flicker.


6				3