INSTALLATION GUIDE | CHAPTER |
|
|
2 STEP 2: RAID 1 MODE |
|
|
2
There are two ways in which you can use RAID 1:
Create a new RAID 1 array using blank disks.
Duplicating a source disk which already has data on it.
Creating a New (Blank) RAID 1 Array
The process for creating a (blank) RAID 1 array is very simple. Just make sure that each disk is functioning in JBOD mode first. The two disks should be the same make and model number. If each disk appears as a separate blank or “Unallocated” volume within your disk management utility, then they should be ready to create an
array.
A)Power the dock off. Both disks should still be in the dock from your JBOD test.
B)Set switches to RAID 1 mode shown in the image on the right.
C)
D)Check for 1 unallocated disk in your disk management utility. Now you are ready to partition and format that disk. As you do so, the invisible “mirrored” disk will receive all of the same data that the visible “master” disk does.
1 |
2 |
3 |
E) See the Initialization section for specific formatting and partitioning instructions for your operating system.
Duplicating a Source Disk Using RAID 1
Before you begin, make sure that each disk is functioning in JBOD mode first. Then, check the data on the source disk. The destination disk should be blank or “Unallocated” and, ideally, should be the same make and
model number.* If both disks appear in your disk management utility, you should now be ready to duplicate.
A)Power the dock off. Both disks should still be in the dock from your JBOD test. Remove the blank disk only. The
B)Set switches to RAID 1 mode shown in the image on the right.
C)
D)Now with the dock still on, you can insert the blank or unallocated disk into
the empty slot. The second disk to be inserted automatically becomes the “destination” or “mirror” disk.
1 |
2 |
3 |
E)Wait an hour or more (depending on the size of your drives) for the “destination” drive to finish automatically copying all of the data from the “source” drive. After that time has elapsed, you can power the dock down and reset it to JBOD mode.
F)Windows users may need to toggle the destination disk “Online” (using Disk Management) in order to access the data on the disk.** If both disks appear with identical information on them, you know the RAID 1 copy procedure was successful!***
* At the very least, you must use another drive that has the same capacity.
**Some users may also need to assign a new drive letter to the destination disk, before Windows will allow you to access it.
***If you would like to continue using your RAID 1 array, simply power the dock down, and reset it to RAID 1. Now when you power the dock
on, it will continue to mirror the destination drive whenever you add new data to the source.
5