Philips FW-V720 manual Clock/Timer, Listening to External Sources, To deactivate the Timer

Clock/Timer

●Before setting the timer, make sure the music source has been prepared.

VCD – Load the disc(s).To start from a specific track, make a programme (refer to “CD/VCD/ MP3-CD Operation - Programming the disc tracks”).

TUNER – tune to the desired radio station. TAPE – load the prerecorded tape into tape deck 2.

3Press à or á on the system repeatedly to set the hour for the timer to start.

4Press í or ë on the system repeatedly to set the minute for the timer to start.

5Press CLOCK•TIMER to store the start time.

➜"TIMER ON" will be displayed and followed by the set timer "XX:XX" and then the selected source.

➜TIMER will remain on the display.

●At the preset time, the selected source will play.

To exit without storing the setting

●Press Çon the system.

To deactivate the TIMER

1Press and hold CLOCK•TIMER for more than two seconds.

2Press Çon the system to cancel the timer.

➜ The display will show "CANCEL" and TIMER will disappear from the display.

To activate the TIMER (for the same preset

time and source)

1Press and hold CLOCK•TIMER for more than two seconds.

2Press CLOCK•TIMER again to store the start time.

➜ The last set timer information will be shown for a few seconds and TIMER will appear on the display.

Notes:

–If the source selected is VCD, playback will begin with the first track of the last selected disc or other trays if disc is empty. If all the disc trays are empty, TUNER will be selected instead.

–During timer setting, if no button is pressed within 90 seconds, the system will exit timer setting mode automatically.

E n g l i s h

External Sources

	STANDBY-ON
	ECO POWER
/	MP3-CD
TITLE
DOLALBUBYM
NAMB NRE
PBC
		V	PRESE
				T	NE
		E	ITL
RETURN	P	R	T	E	X
					T
	DEMO			PLAY•
	STOP/			PAUSE
	CLEAR
	S
		EA AL BUMING
		RCH • TUN

			MUSIC	LEVEL
			INTERACTIVE VU MET
DISPLAY PROG	CLOCK•	AUTO	DUBBING REC
	TIMER	REPLAY
		CD 1•2•3	BAND
	VCD		TUNER
	PAL/
	NTSC
			SOURCE	LEVE
			ON •OFF
			DYNAMIC AMPLIFICATION CON
	TAPE		AUX
		TAPE 1•2	CDR / DVD	MIC/
				LEVEL

2Press AUX (CDR/DVD) repeatedly to select CDR/DVD mode or normal AUX mode.

➜ "CDR/DVD" or "AUX" will be displayed.

● If the sound from the external source is
distorted, select CDR/DVD mode for listening.
Notes:
–	You are advised not to listen to and record from
the same source simultaneously.
–	All the navigation sound control features (DSC or
VAC for example) are available for selection.
–	Refer to the operating instructions for the
connected equipment for details.

Listening to External Sources

1Connect the audio out terminals of the external equipment (TV,VCR, Laser Disc player, DVD player or CD Recorder) to the AUX/CDR IN terminals of your system.

For Recording, please refer to “Tape Operation/Recording”.

29

pg 001-032/V720/21-Eng 29 6/5/01, 6:42 PM 3139 115 20912