Using the document camera
Please read this chapter if the model you purchased is
■How to use the document camera
Using the camera removed from the projector
Using the camera attached on the projector
Status before preparation | 1) Set up arm. | 2) Rotate arm. |
(When stored) |
|
|
3) Raise camera head. |
|
|
Status before preparation (When stored)
3)Remove the document camera from the tray. Pull up toward direction q
1)Disconnect the RGB cable, then slide the lock switch to release lock.
4)Extend the tip resistant bars to set the document camera.
2)While pushing the lock lever in the arrow direction, lift up the document camera.
2
1
5)Connect the document camera and the projector using the supplied RGB cable.
1
PRECAUTIONS
•For camera interconnection, be sure to use the supplied RGB cable (25 cm or 3 m). If you use the other cables, the normal operation may not be achieved and even the malfunction may result.
•When moving the projector with the camera attached, do not grab the camera arm and/or the camera head.
•When moving the projector with the camera attached, first ensure that the camera is securely locked in position on the tray.
•Insert the RGB cable straight and securely until it is fixed in place.
•Do not jolt or force the camera head or camera arm. Doing so could cause malfunction.
•Note that when extending or rotating the camera arm, the arm moves in an arc. Take care not to bump yourself or others with it.
•When placing the projector in the carrying bag, remove the connection cables. Otherwise, damage to the connectors and cables may result.
PRECAUTIONS
•Installation of the document camera onto the tray should be performed in the reverse order shown above.
•When replacing the document camera on the tray, ensure that the lock lever is securely locked in position.
•When using the tip resistant bars, pull them fully until each forms the angle of 90 degree. If you don’t use the bars, the camera may topple over.
Operations
34 | 35 |