Toshiba TLP-X4100E Turning on / OFF Projector, Turning on Projector, Turning OFF Projector

BEFORE OPERATION

TURNING ON / OFF PROJECTOR

TURNING ON PROJECTOR

1	Complete peripheral connections (with Computer, VCR, etc.)
	before turning on projector. (Refer to "CONNECTING TO
	PROJECTOR" on pages 13~15 for connecting that equipment.)
2	Connect a projector's AC Power Cord into an AC outlet. LAMP
	Indicator lights RED, and READY Indicator lights GREEN.
	NOTE : When “On start” function is ON, this projector is turned
	on automatically by connecting AC Power Cord to an
	AC outlet. (Refer to pages 37, 38.)
3	Press POWER ON-OFF button on Top Control or on Remote
	Control Unit to ON. LAMP Indicator dims, and Cooling Fans

start to operate. Preparation Display appears on a screen and count-down starts. Signal from PC or Video source appears after 30 seconds.

Current Input position and Lamp mode status are also displayed on screen for 5 seconds. (Refer to "LAMP MODE" on page 38.)

Input position and

Lamp mode status

Input 1

30

Preparation Display disappears after 30 seconds.

TURNING OFF PROJECTOR

1	Press POWER ON-OFF button on Top Control or on Remote
	Control Unit, and a message "Power off?" appears on a screen.
2	Press POWER ON-OFF button again to turn off projector. LAMP
	Indicator lights bright and READY Indicator turns off. After
	projector is turned off, Cooling Fans operate (for 90 seconds).
	During this "Cooling Down" period, this appliance cannot be
	turned on.
3	When projector has cooled down, READY Indicator lights
	GREEN again and you can turn projector on. After cooling down

completely, disconnect AC Power Cord.

TO MAINTAIN LIFE OF LAMP, ONCE YOU TURN PROJECTOR ON, WAIT AT LEAST 5 MINUTES BEFORE TURNING IT OFF.

Power off?

Message disappears after 4 seconds.

When “Power Management” function is ON, projector detects signal interruption and turns off Projection Lamp automatically. Refer to “Power Management” on page 37.

When WARNING TEMP. Indicator flashes red, projector is automatically turned off. Wait at least 5 minutes before turning on projector again.

When WARNING TEMP. Indicator continues to flash, follow procedures below:

1.Press POWER ON-OFF button to turn a projector off and disconnect AC Power Cord from an AC outlet.

2.Check Air Filters for dust accumulation.

3.Clean Air Filters. (See "AIR FILTER CARE AND CLEANING" section on page 40.)

4.Turn a projector on again.

If WARNING TEMP. Indicator should still continue to flash, contact sales dealer where you purchased this projector or service center.

21