Toshiba B-450-R manual Sensor PCB TR Connector Sensor Holder Harness Rivet

Page 16

2. MAJOUR UNIT REPLACEMENT

EO18-33021

2.5. REPLACING THE MEDIA SENSOR

5)Disconnect the harness from the Sensor PCB (TR), and remove the Sensor PCB (TR) from the Sensor Holder by releasing the two Rivets.

Sensor PCB (TR)

Connector

Sensor Holder

Harness

Rivet

6)Replace the Sensor PCB (TR) with a new one, and then reassemble in the reverse order of removal.

2- 13

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Series Table of Contents Procedure ChecksMajor Unit Replacement Replacing the CPU PC BoardCN9 CN5 CN2 CN1 Release the two Hooks securing the Printer Unit Remove the SMW-3x6 screw, N-3 Nut and Ground Plate Replacing the Motor Ribbon MotorStepping Motor Replacing the PS Unit Hook PS Unit Printer Block Bottom Cover Detach the PS Unit from the Bottom Cover Power Switch Inlet Ass’y Replacing the Print Head Replacing the Media Sensor Replacing the Sensor PCB TRSensor PCB TR Connector Sensor Holder Harness Rivet Replacing the Sensor PCB LED Release the two Hooks securing the Printer Unit Printer Unit Harness Rivet Sensor PCB LED Troubleshooting
Top Page Image Contents