Toshiba SD-R1202 installation instructions CD-RW/DVD-ROM Front Panel, CD-RW/DVD-ROM Back Panel

Page 13

1.Turn CD-RW/DVD-ROM drive power OFF.

2.Insert a solid bar (i.e. large paper clip*) into Emergency Eject hole and push in as shown in the picture below.

3.CD-RW/DVD-ROM tray will open/eject.

This procedure cannot be repeated without cycling the drive’s power. After the media is removed and the loading tray is closed, the tray will not reopen without first turning the power ON/OFF.

*Use a bar that is less than 1.5mm in diameter. Do not insert more than 50mm in depth as this may damage the drive.

CD-RW/DVD-ROM FRONT PANEL

The photo below illustrates the following features of the SD-R1202 CD-RW/

DVD-ROM front panel:

 

"Loading Tray

# Eject Button

$ Busy Light

% Emergency Eject Hole

CD-RW/DVD-ROM BACK PANEL

The photo below illustrates the following features of the SD-R1202 CD-RW/DVD- ROMs back panel:

" Digital Audio Out Connector

% ATAPI Connector

$ Analog Audio Out Connector

& Power Connector

# Mode Select Jumper

 

Page 12 Page 14
Image 13
Page 12 Page 14
Contents CD-RW/DVD-ROM Drive Page CD-RW/DVD-ROM Drive Where is this limited warranty valid? Disclaimer and limitation of remedy Table of Contents System Requirements Checking Your KIT PackagingPlacing CD-RW/DVD-ROM Inside Your Computer Setting JumpersCable Locations on Rear of CD-RW/DVD-ROM Page Atapi CD/DVD Software Driver Completing InstallationEmergency Eject CD-RW/DVD-ROM MediaCD-RW/DVD-ROM Back Panel CD-RW/DVD-ROM Front PanelTechnical Support Specifications DVDPage 460023-B0
Top Page Image Contents