Setting Jumpers

The following steps must be performed to properly install your CD-RW/DVD-

ROM.

!Set drive’s jumpers

!Connect audio cable

!Attach IDE BUS cable

!Connect power cable

!Mount CD-RW/DVD-ROM

!Install CyberLink PowerDVD™ software (used for viewing DVD movies)

!Install VOB InstantCD/DVD software (used for recording CDs)

The mode select jumpers are six (6) straight pins located on the rear of the CD-RW/ DVD-ROM. By placing a jumper on the pins, you can select the following func- tions:

CS: – Drive is configured using host interface signal CSEL

SL: – Configures drive as Slave

MA: – Configures drive as Master (default mode)

C S M

S L A

Mode Select Jumpers

In most installations, jumper should remain in MA (Master) position (factory default). It is recommended that you install your CD-RW/DVD-ROM only on the secondary IDE BUS. If you are installing on primary IDE BUS, your hard drive would then be the Master, and you should set your CD-RW/DVD-ROM to the Slave position (SL).

PLACING CD-RW/DVD-ROM INSIDE YOUR COMPUTER

Now that you have set your drive’s jumpers, you are ready to install your CD-RW/DVD-ROM inside your computer.

☞IMPORTANT: Disconnect power from your computer system before beginning installation.