Toshiba P32LS1 owner manual Take measures to prevent the unit from falling down

Page 7

Take measures to prevent the unit from falling down.

If not, the unit may fall down and cause injury.

Do not block the ventilation holes on the unit.

The inside of the unit will overheat if the ventilation holes are sealed, which may result in a fire.

When installing the unit near a wall, keep the unit at least 10 cm from the wall.

Do not place the unit in a closet or bookshelf where ventilation is poor.

Do not spread a newspaper, tablecloth or curtain over the unit.

Do not place the unit on an unstable surface, such as a rug, or a cushion, etc.

Do not place the unit so that it is facing up or down, or on its side.

Precautions for moving the unit:

When moving the unit, be sure to remove the plug from the wall outlet and disconnect wiring cables between equipment and detach any securing anchors. If not, fire or electric shock may result if the power cord is damaged, injury may occur by the unit falling down.

When unpacking or carrying the unit, at least two people are needed. Make sure the units upright,

Do not carry the unit with the screen facing up or down.

Handle the unit so as not to jolt the unit.

Do not overload outlets or cables beyond their capacity.

Do not use extension cords.

Electric shock or fire may result.

Use

Do not pull the power cord when removing the plug from the wall outlet.

If the power cord is yanked, the cord may become damaged and fire or electric shock may occur. Always hold the plug firmly when removing it.

Never insert or remove the power plug with wet hands.

This may cause electric shock.

7

Image 7
Contents 23566558 LCD MonitorContents Malfunction or Trouble Safety InstructionsInstallation Use Insert the power plug fully into a 100∼240 V AC outletCleaning Follow these precautions for the power cord and plugTake measures to prevent the unit from falling down Do not climb or stand on the unit Remove the power plug before cleaning On disposal or handing over to a new owner On usageExemptions Features Front Names and Functions of Controls UnitSide Controls Back Infrared Emittor Names and Functions of Controls Remote controlRemove the battery cover, and insert batteries Battery installationEffective range Please check all are supplied Supplied accessoriesYou can select Video input from 4 terminals below ConnectionOutput follows RGB Analog ConnectionYou can select RGB input from 2 terminals below VIDEO-1 has priorityBack side Connecting external speakersAbout external speakers To connect speakersBack Connecting the power cordExample To connect equipmentsVIDEO-1 Video Audio Video OUT Audio OUT Video and Audio connection exampleRGB RGB Audio To a service technician InstallationRemove the frame from the bracket How to install the monitor on the wallWall hanging accessory Remove the stand of the LCD monitorWire before hanging on the wall Using supplied screws, fix the frame on the LCD monitorMount the LCD monitor on the bracket How to install the LCD monitor to the ceiling How to install the LCD monitor on the floorUnit mm DimensionSpecifications Back view A-angleMain power switch Power on/offPower button on the Remote control Function of each button Menu FunctionPC Auto Setup Writing Exit Reset Menu setting chartTerms of functions Menu display chart YUV To connect in series Control by ComputerConnection TransferFormat for Rgbdvi input signal Timing Input signalFor inquiries and repair Guide to Simple Problem SolvingPage About trademarks Annex