Toshiba PCX2000 owner manual QHow to connect the Cable Modem to the PC via the USB ?

Q & A

Q: How to connect the cable modem to the hub/switch via the 10BASE-T ?

A:Cable Modem is connected to the uplink port on the hub/switch, or use cross-over Ethernet cable to connect the normal port on the 10BASE-T hub/switch.

(See below)

PCPC

Cross-over Cable or connect to uplink port

10BASE-T

USB Cable

Cable TV Coax

HUB/ Switch Cable Modem

Q:How to connect the Cable Modem to the PC via the USB ?

A:Plug the Type A end of the USB cable into the USB port of your PC. And plug the Type B end of the USB cable into the USB port located in the back of Cable Modem. (See above)

NOTES: Macintosh computers do not support networking through USB. Mac users must use an Ethernet connection.

Q:Do I need to turn off the Cable Modem ?

A:No. You can leave Cable Modem powered up.

Q: How can I connect multiple PC to the Cable Modem?

A:You can use 10BASE-T and USB interfaces simultaneously, and also can use a 10BASE-T hub or switch for physical connection. Cable Modem is controlled by the Cable Operator to allocate how many PCs are available. Please contact your local Cable Operator to activate multiple PCs under the Cable Modem.

Q: Where can I download the driver for Cable modem?

A:In case of use 10BASE-T interface, the Cable Modem is a stand-alone device that has a 10BASE-T port. All workstations or hub must have a 10BASE-T port or card to connect to the Cable Modem. Since the Cable Modem is a stand alone device, there is no special driver needed on the workstation.

In case of use USB interface, the Cable Modem that connects to a PC running

15