Moxa Technologies A51, A60 manual SW1

Page 23

Operation •	• Chapter 3

In the graph, TA, TB, RA and RB could be either from RJ-45 or Terminal Blocks. The settings of the switches for each A50 (or

A51) are as follows:

SW1
Full-duplex mode			Off
SW2 for Master	Pin1 Pin2 Pin3 Pin4
TxD always enabled	On	Off	X	X
RxD always enabled	X	X	On	Off
SW2 for Slaves	Pin1	Pin2	Pin3	Pin4
TxD enabled by RTS	Off	On	X	X
RxD always enabled	X	X	On	Off

2-wire Half Duplex

15

Image 23

Contents A50/A51/A60 A50/A51 A60 Copyright Notice Moxa Internet Services Table of Contents Part II A60 RS-232 Surge Protection Page Overview IntroductionIntroduction Features and SpecificationsSpecifications A50/A51 with Mounting Kit Package Check List Introduction Switch Function Description Installation ProcedureSwitch settings table of SW1 and SW2 is as follows LED IndicatorsRS-422/RS-485 Pinouts A50/A51 RJ-45 Jack Terminal Block Connector Pinouts Signals Chapter Operation Point-to-point Wire Full DuplexWire Half Duplex Multidrop SW1 DTE Simplex/Transmit, Receive A50/A51A50/A51 Self Test Operation Appendix a RS-232 Pinouts & Cable Wiring Appendix a RS-232 Pinouts and Cable Wiring Appendix a RJ-45 Connector DB-25 Female P e n dxi B Appendix B Impedance Matching and Termination Resistors Appendix C Troubleshooting Appendix C Troubleshooting Chapter Introduction Features A60 with Mounting Kit ~32~ Installation TxD indicator signal from local port RxD indicator signal from remote port ~36~ Ppendix a Appendix a ∙ RS-232 Pinouts and Cable Wiring ∙ ~40~ Ppendix B