LIT_PRO7000_manual.qxd 11/10/2003 4:30 PM Page 26
TROUBLESHOOTING
PROBLEM – The PRO 7000 is not receiving power.
Possible Cause #1:
The PowerSource is not turned on.
Possible Solutions:
•Press the ON/OFF button on the PowerSource.
•Make sure the AC power cord is plugged into a properly grounded 120V wall outlet.
Possible Cause #2:
Too many devices are connected to the PowerSource causing an overload and tripping the thermal circuit breaker. Please note that the total power consumption of all the components plugged into the PowerSource should not exceed 1800 watts.
Possible Solutions:
•Press the thermal circuit breaker button labeled BREAKER 15A on the back panel of the PowerSource to reset.
•Allow 10 minutes from the time the circuit breaker is initially tripped before attempting
to reset it. If reset too quickly, the breaker may sense a power overload and prevent the unit from operating.
• Disconnect any component that may overload the PowerSource.
25