Dell GX270 manual Replacing the Control Panel

Page 7

1

computer cover tab (remove the CD drive to access this tab)

4

bottom panel

 

 

 

 

2

top-panel tabs

5

computer cover screw

 

 

 

 

3

top panel

6

computer cover tabs (2)

 

 

 

 

2.To prepare the computer cover for removal, release the three computer cover tabs (one tab is located by the CD drive and two tabs are located by the I/O panel).

NOTE: To release the tab located by the CD drive, you can pry the computer cover away from the computer and pull out the tab.

3.If necessary, remove the computer cover screw.

4.Close the computer and remove the computer cover.

5.Remove the screw that secures the control panel to the computer, and pull the control panel away from the computer.

Replacing the Control Panel

Small Form-Factor Computer

1.Replace the control panel and the control-panel shield.

Image 7
Contents June 2004 Rev. A01 Removing the Chassis Intrusion Switch Chassis Intrusion SwitchResetting the Chassis Intrusion Detector Replacing the Chassis Intrusion SwitchBack to Contents Removing the Control Panel Control PanelSmall Form-Factor Computer Small Mini-Tower Computer Small Desktop ComputerReplacing the Control Panel Small Desktop Computer Small Mini-Tower Computer Small Form-Factor and Small Desktop Computers Opening the Computer CoverSmall Mini-Tower Computer Closing the Computer Cover Removing the I/O Panel PanelReplacing the I/O Panel Removing the Power Supply Power SupplySmall Desktop Computer Replacing the Power Supply Small Form-Factor System Board System BoardSmall Mini-Tower System Board Resetting Cmos Settings Jumper SettingsRemoving the System Board Replacing the System Board Back to Contents When Working Inside Your Computer When Using Your ComputerGeneral Protecting Against Electrostatic Discharge Battery Disposal