Dell 160L manual Replacing the Power Supply, DC Power Connectors

Page 10

1screws (4)

2power supply

5.Remove the power supply from the computer.

Replacing the Power Supply

1.Slide the power supply into place.

2.Replace the four screws that secure the power supply to the back of the computer.

3.Reinstall the fan assembly.

4.Reconnect the DC power cables to the drives and system board.

5.Replace the computer cover.

6.Connect the AC power cable to the AC power connector on the back of the power supply.

NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.

7.Connect your computer and devices to electrical outlets, and turn them on.

DC Power Connectors

Power Supply DC Connector Pin Assignments

Main Power Connector

 

 

 

 

Pin

Signal Name

 

Number

 

 

 

 

 

1

+3.3 VDC

 

 

 

22-AWG Wire

Orange

Image 10
Contents Model MTC2 June 2003 Rev. A00 Control Panel Removing the Control PanelReplacing the Control Panel Replacing the Computer Cover Panel Removing the I/O PanelPage Replacing the I/O Panel Back to Contents Power Supply Removing the Power SupplyReplacing the Power Supply DC Power ConnectorsPeripheral Power Connectors Volt Power ConnectorFloppy Drive Power Connector System Board Jumper SettingsSystem Board Components Resetting Cmos Settings Jumper Setting DescriptionReplacing the System Board Removing the System BoardReplacing the System Board Removing the Computer Cover
Related manuals
Manual 38 pages 54.87 Kb