Dell 160L manual Removing the Control Panel

Page 2

Back to Contents Page

Control Panel

Dell™ OptiPlex™ 160L Service Manual

Removing the Control Panel

Replacing the Control Panel

CAUTION: Before you perform this procedure, see the safety instructions in your Setup and Quick Reference Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as the back panel) on the computer.

NOTICE: Before you disconnect a device from the computer or remove a component from the system board, verify that the standby power light on the system board has turned off. To locate the light, see "System Board Components."

1.Shut down the computer through the Start menu.

2.Ensure that your computer and attached devices are turned off. If your computer and attached devices did not automatically turn off when you shut down your computer, turn them off now.

NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.

3.Disconnect any telephone or telecommunication lines from the computer.

4.Disconnect your computer and all attached devices from their electrical outlets, and press the power button to ground the system board.

CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.

5.Remove the computer cover.

NOTICE: Before touching anything inside your computer, ground yourself by touching an unpainted metal surface, such as the metal at the back of the computer. While you work, periodically touch an unpainted metal surface to dissipate any static electricity that could harm internal components.

Removing the Control Panel

1.Disconnect the control panel cable from the connector on the system board.

2.Press the control panel lever to release the panel from the notch on the computer.

1control panel

2control panel lever

Image 2
Contents Model MTC2 June 2003 Rev. A00 Control Panel Removing the Control PanelReplacing the Control Panel Replacing the Computer Cover Panel Removing the I/O PanelPage Replacing the I/O Panel Back to Contents Power Supply Removing the Power SupplyReplacing the Power Supply DC Power ConnectorsFloppy Drive Power Connector Volt Power ConnectorPeripheral Power Connectors System Board Components Jumper SettingsSystem Board Resetting Cmos Settings Jumper Setting DescriptionReplacing the System Board Removing the System BoardReplacing the System Board Removing the Computer Cover
Related manuals
Manual 38 pages 54.87 Kb