Back to Contents Page
Microprocessor Airflow Shroud — Dell Precision™ 650 Computer
Dell Precision™ Workstation 650 and Dell Precision Workstation 450 Service Manual
Removing the Microprocessor Airflow Shroud
Installing the Microprocessor Airflow Shroud
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the System Information Guide.
Removing the Microprocessor Airflow Shroud
1.Press down and back on the indentations at the top corners of the shroud.
The top anchor tabs disengage from the anchor slots.
2.Lift the airflow shroud out of the computer.
1airflow shroud
2indentations (2)
3bottom anchor tabs (2)
4side anchor tabs (2)
5top anchor tabs (2)
Installing the Microprocessor Airflow Shroud
1.Insert the bottom anchor tabs into the anchor slots.
2.Align and insert the side anchor tabs into the anchor slots.
3.Press the indentations until the top anchor tabs on the shroud snap securely into place.
4.Close the computer cover.
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
5.Connect your computer and devices to electrical outlets, and turn them on.