1base
2release tabs (2)
3AGP retention spring
3.If necessary, disconnect any cables connected to the card.
4.Grasp the card by its top corners, and ease it out of its connector.
5.If you are removing the card permanently, install a filler bracket in the empty
If you need a filler bracket, contact Dell.
NOTE: Installing filler brackets over empty
6.Lower the retention arm and press it into place, securing the card(s) in the computer.
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
7.Close the computer cover, reconnect the computer and devices to electrical outlets, and turn them on.
8.Remove the card's driver from the operating system.
9.If you removed a sound card:
a.Enter system setup, select Integrated Devices, and then change the setting for Sound to On.
b.Connect external audio devices to the audio connectors on the computer back panel.
10.If you removed an
11.Connect the network cable to the integrated connector on the computer back panel.