DELL™ OPTIPLEX™ 7010 TECHNICAL GUIDEBOOK VER1.2
COMMUNICATIONS - INTEGRATED LAN (CONT.)
INTEGRATED INTEL® 82579 GIGABIT1 | MT |
| DT |
| SFF | USFF |
ETHERNET LAN 10/100/1000 (CONT.) |
|
| ||||
|
|
|
|
|
| |
|
|
|
|
|
|
|
Environmental |
|
|
|
|
|
|
|
|
|
|
|
| |
Operating temperature |
| 0°C to 85°C (32° F to 185° F) |
| |||
|
|
|
| |||
Operating humidity |
| 20% to 80% |
| |||
|
| |||||
Operating System Driver Support | Windows 7 32/64, Windows XP 32/64, Vista | |||||
|
|
| 32/64 |
| ||
|
|
|
|
| ||
|
|
|
|
| ||
Manageability (examples WOL, PXE) |
|
| WOL, PXE 2.1 |
| ||
|
| |||||
Management Capabilities Alerting | Intel® Standard Manageability, 3rd generation | |||||
i5/i7 processors with vPro Technology |
| |||||
|
| |||||
1This term does not connote an actual operating speed of 1 Gb/sec. For high speed transmission, connection to a Gigabit Ethernet server and network infrastructure is required.
COMMUNICATIONS – NETWORK ADAPTER (NIC)
NOTE: MT supports full height (FH) cards and DT and SFF supports low pro fi le (LP) cards .
BROADCOM NETXTREME 10/100/1000 | MT |
| DT |
| SFF |
| USFF | |
PCIE GIGABIT1 NETWORKING CARD |
|
|
| |||||
|
|
|
|
|
|
| ||
Connector Type |
|
|
| RJ45 |
| |||
|
|
| ||||||
Data Rates supported |
| 10/100/1000 Mbps Half/Full duplex | ||||||
|
|
|
|
|
|
|
| |
Controller Details |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| ||
Controller bus architecture (example PCIe 1.0a x1) |
|
| PCIe c1.0a x1 |
| ||||
|
|
|
|
| ||||
Integrated memory |
|
| 64KBytes RX, 8KBytes TX |
| ||||
|
|
|
|
| ||||
Data transfer mode (example |
|
|
| |||||
|
|
|
|
| ||||
Power consumption (full operation per data rate connection speed) |
|
| 2.84W (860mA @ +3.3V) |
| ||||
|
|
|
|
| ||||
Power consumption (standby operation) |
|
| Less than 300mW |
| ||||
|
|
|
| |||||
IEEE standards compliance (example 802.1P) |
| 802.3, 802.2, 802.3x, 802.1p |
| |||||
|
|
|
|
| ||||
Hardware Certifications (example FCC, B, GS mark…) |
|
| FCC B, VCCI B, CE |
| ||||
|
|
|
|
|
| |||
Boot ROM Support |
|
|
| No |
| |||
|
|
|
|
|
|
|
| |
Network Transfer Mode (example Full Duplex, Half Duplex) |
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| |
Network Transfer Rate (example | ||||||||
* Depends on the system environment. | ||||||||
| ||||||||
|
|
|
|
|
|
|
| |
1This term does not connote an actual operating speed of 1 Gb/sec. For high speed transmission, connection to a Gigabit Ethernet server and network infrastructure is required.
24