Ground Clamp Antenna Lead-In Wire

Safety Information (continued)

14.Overloading - Do not overload the wall outlet where this device is being connected. Do not overload this device. Ensure the total load to this device does not exceed that which is listed in the Speciﬁcations section of this manual.

15.Servicing - There are no user-serviceable components within this device. Removal of any cover from this device may present a shock hazard, and/or void the warranty.

16.Damage Requiring Service - If any type of damage occurs to this device, immediately disconnect it from the wall outlet. Do not use the Power switch or line cord into the rear of the device to disconnect power. Notify APC Technical Support or Customer Service at once.

17.Replacement Parts - There are no components within this device that can or should be removed/replaced unless it is by an APC-qualiﬁed technician.

18.Periodic Inspection - Inspect the line cords. telephone/data cords, or DSS/ Cable TV coaxial cables connected to this device to ensure they remain fully pushed in or attached, and that they are not frayed or otherwise damaged.

EXAMPLE OF ANTENNA GROUNDING AS PER NATIONAL ELECTRIC CODE (NEC)

Ground

Clamp

Antenna Lead-In Wire

		Antenna Discharge Unit
		Grounding Conductors
		Ground Clamps
	Electric Service	Power Service Grounding
	Equipment	Power Service Grounding
	Equipment	Electrode System
		Electrode System