Chauvet DMX-4 LED user manual Orientation, Rigging

Page 7

Mounting

Orientation

The DMX-4 LED may be mounted in any position, provided there is adequate room for ventilation.

Rigging

Be sure that the structure can support the weight of the fixture. Please see the “Technical Specifications” section of this manual for a detailed weight listing. Mount the fixture securely. This may be done with a screw, nut and bolt, or a hanging clamp. The hole in each bracket is 13 mm in size. When rigging consider routine maintenance and control panel access. Please see the following notes on installation.

∙The back plate may be reversed for an alternate rigging configuration. See the section on the following page for details on how to do this.

∙Safety cables must always be used.

Mounting bracket

3. Setup

7

12/10/2010 5:16 PM

Page 6 Page 8
Image 7
Page 6 Page 8
Contents DMX-4 LED Table of Contents Manual Conventions What is includedBefore YOU Begin Unpacking InstructionsSafety Instructions Product Overview IntroductionAC Power SetupChanging between Dimmer and Switch Rigging OrientationBack Panel Alternate Rigging Configuration Operating Instructions Configuring the Starting AddressDMX Mode Standalone ModeChannel Personality DMX Channel ValuesAppendix General TroubleshootingDMX Data Cable DMX PrimerFixture Linking Daisy Chain Data CablingSetting the Starting Address Cable ConnectorsSetting up a DMX Daisy Chain Pin to 5-Pin Conversion ChartReturns Procedure General MaintenanceClaims Contact US Technical Specifications
Top Page Image Contents