ETA-ECS3
Power Sequencer & Conditioner
AC POWER CORD RETAINER SYSTEM
Your ETA Systems product comes with an AC Mains Power Cord Retainer System. This system prevents the power cord from being removed without the use of a screwdriver. Follow these steps for installation.
Note: Installation of this product must be done by a certified electrician for a permanently connected apparatus provided neither with an
1.Locate the 6/32 screw, retainer clip, and zip tie.
2.Locate the AC wall outlet that will be used to power the Atlas Power product. Remove the center screw securing the cover plate to the AC outlet.
4. Wrap the zip tie around the power cord as shown in Figure 4.
Figure 1
3.Place the screw through the retainer clip and insert into the cover plate making sure to securely tighten. Inset the zip tie through the retainer clip slots as shown in Figure 3.
Figure 4
5.Feed the end of the zip tie through the retainer and pull tightly to secure. Note: Some adjustment of the retainer may be needed in order to properly align it as shown in Figure 6.
Figure 5 | Figure 6 |
6. Cut the excess zip tie off as shown in Figure 7.
Figure 2 | Figure 3 |
Figure 7
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone:
– 11 – | ETAsys.com |
Specifications are subject to change without notice.