|
|
Power Sequencer & Conditioner | |
SPECIFICATIONS |
|
Type | Power Sequencer, Power Conditioner & Suppressor |
Sequencer Sections | 3, Fixed Time of 3 Seconds Between “On” Seq. 2 & 3, “Off” 2 & 1 |
Load Rating | 15A Continuous |
Safety Listing | ETL (UL 60065 Standard) |
Front Panel |
|
AC Outlets | 2 Unswitched |
Lights | 1 Pull out LED with Dimmer Switch |
Activation Switch | Momentary |
Circuit Breaker | 15A Resettable |
AC Mains Voltmeter | Three Digits (Digital) |
Indicators | Sequencer Sections 1, 2 & 3, Abnormal Voltage, AC Fault, Breaker Open, Wiring Fault |
Rear Panel |
|
AC Outlets | 7 Total, Sequence Section 1 (3 outlets), Sequence Section 2 (2 Outlets), |
| Sequence Section 3 (1 outlet), Unswitched (1 Outlet) |
External Switch Activation Trigger | Momentary Contacts, 2 Position Euro/Phoenix 5.08mm Type Connector |
External Voltage Activation Trigger | |
DC Output | 12VDC 100mA Output Paralleled to Sequencer Section 3 Timing |
LED Light Socket | XLR Socket to Provide 12VDC for Optional 16" Gooseneck Lamp, |
LED Light Switch | Two Position On/Off |
Grounding Terminal | Hand Screw Type Terminal to Chassis Ground |
AC Mains Power Cord | 9' (3 Meters) |
Technical Data |
|
Current Rating | 15 amps |
Power Consumption | 12 watts |
Operating Voltage | 102 - 132VAC |
High Voltage Surge Protection | Trigger at 133VAC, 1ms Typically |
Low Voltage Protection | Trigger at 101VAC, 1ms Typically |
Voltmeter Accuracy | ±1.5VAC |
Spike Protection Modes | DCS (Dual Clamping Suppression) Circuitry on Incoming AC Mains and Each |
| Sequential Section Output |
Min. Spike Clamping Voltage | 460 VRMS @ 3,000A |
Max. Spike Clamping Voltage | 6kV |
Max. Spike Clamping Resp. Time | 1 nanosecond |
Spike Clamping Voltage @ 100A | 1250Vp for 20μs |
Maximum Surge Current | 6,500A |
Energy Rating @ 2ms | 2000 Joules |
Noise Attenuation EMI/RFI Seq. Section 1 & 2 | 10dB @ 10 kHz, 40dB @ 100 kHz, 100dB @ 10 MHz |
Temperature Range | 5º to 35º C |
Humidity Range | 5% to 95% R.H. |
Mechanical |
|
Chassis Finish | Black |
Mounting | Rack Mount, 19", 1 RU |
Dimensions | Height 1.75" (44.45mm) x Width 19" (482.6mm) x Depth 8.5" (215.9mm) |
Weight | 7.6 lbs (3.45kg) |
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone:
– 12 – | ETAsys.com |
Specifications are subject to change without notice.